Transporting/Storage - Honda WB20XT Guide De L'utilisateur

9. TRANSPORTING/STORAGE

• To avoid severe burns or fire hazards, let the engine cool before
transporting the pump or storing it indoors.
• When transporting the pump, turn the fuel valve to the OFF position,
and keep the pump level to prevent fuel spillage. Spilled fuel or fuel
vapor may ignite.
Before storing the pump for an extended period;
1. Be sure the storage area is free of excessive humidity and dust.
2. Clean the pump interior.....
Sediment will settle in the pump if it has been used in muddy or sandy water,
water containing heavy debris.
Pump clean water through the pump before shutting down or impeller may
be damaged when restarting. After flushing, remove the pump drain plug,
drain as much water as possible from the pump housing and reinstall the
plug.
3. Drain the fuel.....
<WB20XT>
a. Place an approved gasoline container below the carburetor, and use a
funnel to avoid spilling fuel.
b. Move the fuel valve lever to the OFF position, loosen the carburetor drain
bolt by turning 1 to 2 turns counterclockwise and drain the fuel in the
carburetor.
c. Remove the sediment cup, and then move the fuel valve lever to the ON
position and drain the fuel in the fuel tank.
PUMP DRAIN PLUG
d. After all fuel has drained into the container, tighten the carburetor drain
bolt securely.
e. Reinstall a new O-ring and sediment cup.
f. Move the fuel valve lever to the OFF position.
28
WASHER
DRAIN BOLT
FUEL VALVE LEVER
ON
FILTER
O-RING (Replace)
SEDIMENT CUP