Assembling The Pump And The Penile Tube; Mounting The Constriction Ring; Using The Pump To Create An Erection - Owen Mumford Rapport Classic Mode D'emploi

The unique shape also allows easy passage of the constriction ring
off the transfer sleeve and onto the base of your penis.
Because the transfer sleeves are made of a soft material they help
to make a good seal against your body to achieve the vacuum inside
the penile tube which creates the erection.

Assembling the Pump and the Penile Tube

The pump head has two small pegs on each side above the O-ring; these
should be positioned into the two grooves on the top of the penile tube.
The two parts are then locked together with a twist so that the two pegs
slot down and locate at the lower end of the groove. (Fig.1)
If these two parts are then locked together correctly it will ensure the unit
is sealed tight enough to create a vacuum inside the penile tube. (Fig.2)

Mounting the Constriction Ring

When you have selected the most suitable transfer sleeve, place
it firmly onto the clear end of the penile tube. (Fig.3)
Fit the loading cone onto the transfer sleeve and apply a little water
soluble lubricating jelly to the top of the cone.
Holding the constriction ring by outer handles, simple stretch and pull
the ring down the loading cone until it slips onto the transfer sleeve.
Make sure that the constriction ring is located into the flat groove at the
center of the transfer sleeve. (Fig.4)
The constriction ring is now mounted and ready for use.
Before using the Rapport™ Classic V.T.D. make sure you use the water
soluble lubricating jelly to lubricate the end of the transfer sleeve. Also
lightly lubricate your penis to prevent it from sticking to the inside of the
penile tube during insertion or while using the pump. (Fig.5)
1 2
4 5
10
3
O-ring
Transfer Sleeves

Using the Pump to Create an Erection

1
To ensure a vacuum will be created, insert your penis into the penile
tube and apply slight pressure to seal the transfer sleeve against your
body at the base of the penis. (Fig.6)
Make sure the constriction ring on the transfer sleeve is in the correct
position with the handles to the top and bottom.
To prevent the penile tube from fogging, submerge the tube only in
warm water (never immerse the vacuum pump itself in water). Again,
make sure the handles of the constriction ring are positioned to the
top and bottom of the penis. This will be more comfortable in use and
allow easier ejaculation.
Steady the tube with one hand to prevent any jerky movements and
squeeze and release the pump handle with the other hand. This works
the pump to create the necessary vacuum. (Fig.7)
You may find that creating the erection will be easier and more
comfortable if you stand up to use the pump. You can always steady
the tube by placing it on a flat surface such as a table.
If you are unsteady when standing up, create the erection sitting
down on the edge of a chair.
2
Continue pumping slowly to create the erection. If you feel any pain,
stop pumping and press the pressure release button on the pump
to eliminate the vacuum. Take your penis out of the tube, then reinsert
it and start pumping again slowly. Repeat this if necessary. Pumping
slowly is most beneficial, as this draws the blood into your penis at
the correct rate.
Please take care not to pump too fast as this may
cause bruising.
NOTE: For your safety, the vacuum pump is unable to reach a
dangerous pressure. The vacuum is automatically released through
the release valve when pressure reaches 360mm of Hg.
6 7
11