Protective Equipment - Pro-Point 8868242 Instructions

VI .O
INTRODUCTION
The 2-in-l Hot Air Soldering
and heat gun to remove and reinstall circuit board components.
SAFETY
WARNING! Read and understand
tool. The operator
risk of personal
Keep this manual for safety warnings,
inspection and maintenance
WORK AREA
Operate in a safe work environment.
1.
well-lit and free of distractions.
in a shadow.
2. Keep anyone not wearing the appropriate
from the work
Store tools properly
3.
the reach
Do not install or use in the presence
4.
liquids.
PERSONAL
WARNING! Wear personal
Canadian Standards
Standards Institute
PERSONAL
Always wear impact safety goggles that provide front and side
1.
protection
with CSA Z94.3-07
work performed.
2. Wear gloves that provide protection
to reduce
3. Wear protective
tool.
Visit www.princessauto.com
2-in-l Hot Air Soldering
Rework Station combines
must follow
injury and/or
instructions.
area.
in a safe and dry location.
of children.
SAFETY
protective
Association
(ANSI).
PROTECTIVE
for the eyes. Eye protection
or ANSI Z87.1 standards
the effects of tool
clothing designed
for more information
Rework Station
all instructions
basic precautions
damage to the equipment.
precautions,
Keep your work area clean,
Place lights so you are not working
safety equipment
of flammable
equipment
(CSA) or American
EQUIPMENT
equipment
based on the work materials
vibration.
for the work environment
a soldering
before using this
to reduce
operating or
Keep tools out of
gases, dust or
approved by the
National
should comply
based on the type of
8868242
iron
the
away
or
and
3