PRO-POINT 8868242 Instructions page 9

VI .O
OPERATION
WARNING! Make sure the ON/OFF
is in the OFF position
to a power outlet.
Letter references
Identification Key.
BEFORE EACH
1. Clear the work
Make sure the work area is well ventilated,
2.
irritating fumes.
3. Clean the heat gun nozzle of any residue from previous work.
3.1 Only clean the soldering
4. Wet the soldering
5. Place the soldering
cradles (C and L).
Insert the soldering iron connector (E) into the control unit (N) and turn
6.
clockwise to lock in place. Repeat with the heat gun connector
Plug the control unit into the power supply.
7.
8. Both LCDs will briefly display all screen elements,
unit performs
9. The control unit will switch on automatically.
the SET temperature
Tap the 'UP' or 'DOWN'
10.
temperature
decrease
Press the OC/OFbutton (J) to switch from Celsius or Fahrenheit.
11.
Both the tool temperature
default is Celsius.
12. Press the power button (D or G) to supply power to the tool. The
tool will heat up until it reaches the set temperature.
temperature
soldering
Visit www.princessauto.com
2-in-l Hot Air Soldering
before
in parenthesis
USE
area of combustible
iron sponge.
iron (B) or heat gun (M) in their respective
a self-diagnosis.
(P).
one degree. Press and hold the button to increase or
the temperature
will display the tool's current temperature
iron's tip or the heat gun's element.
for more information
Rework Station
switch
connecting
(A) refer to the included
or flammable
iron tip of residue after it is hot.
button (H and l) to change the SET
quickly.
and set temperature
(D and G) for each tool
the power supply
materials.
as there may be toxic or
as the control
Each LCD will show
will switch. The
The tool
at the
8868242
cord
(F).
9