Power Cord - Pro-Point 8868242 Instructions

8868242
POWER CORD
Insert the power cord plug directly to the power supply whenever
possible.
tool's power cord cannot reach a power supply from the work area.
Do not operate this tool if the power cord is frayed, damaged
2.
poorly spliced, as an electric shock may occur, resulting in personal
injury or property damage.
2.1 Inspect the tool's power cord for cracks, fraying or other faults
in the insulation or plug before each use.
2.2 Discontinue
warm while operating
Keep all connections
3.
electric shock. Do not touch the plug with wet hands.
Prevent damage to the power cord by observing
4.
4.1 Do not pull on the cord to disconnect
4.2 Keep the cord away from heat, oil, sharp edges or moving
parts.
4.3 Never use the cord to carry the tool.
4.4 Place the electrical
coming
workpiece.
5. Make sure the cord is located so that it will not be stepped
tripped over or otherwise
6. Do not wrap the cord around the tool, as sharp edges may cut
insulation
either hang on a hook or fasten with a device to keep cord together
during storage.
POWER TOOL
1. DO NOT use any power tool with a malfunctioning
control. A power tool that fails to respond to the controls is
dangerous
repair and verify the power tool is operating
be used.
6
2-in-l Hot Air Soldering
Use extension cords or surge protectors
use if a power cord feels more than comfortably
dry and off the ground to reduce the risk of
into contact with the tool and getting caught by the
The cord should always stay behind the tool.
or cause cracks if wound too tight. Gently coil cord and
PRECAUTIONS
and could cause an injury. A qualified technician
Rework Station
the tool.
cord in a position that prevents it from
subjected to damage
For technical
only when the
the following:
the plug from an outlet.
or stress.
power switch or
correctly before it can
questions call 1-800-665-8685
or
on,
must