Troubleshooting The Soldering Iron; Maintenance; Replacing The Soldering Iron Tip - Toolcraft To-8962 Mode D'emploi

10 Troubleshooting the soldering iron

Problem
TEMP display shows - - -, and
flickers
TEMP display shows - - -, and
flickers
TEMP display shows - - -, and
flickers

11 Maintenance

11.1 Replacing the soldering iron tip

Replace the soldering iron tip if it shows signs of significant wear and tear or if it no longer performs effectively.
1. Switch the main unit off by flipping the power switch I/O into the position O.
2. Disconnect the mains cable from the product.
3. Let the soldering iron cool down to room temperature.
4. Disconnect the soldering iron from the main unit.
5. Remove the soldering tip by unscrewing it. See figure.
6. Replace the soldering tip with a new one. Refer to
22
Possible cause
Soldering iron is disconnected
Sensor fault
Heater fault
Spare parts [} 24]
Suggested solution
Connect the soldering iron to the sol-
dering iron connection port.
Contact technical support.
Contact technical support.
for more information.