Mains Cable; Soldering Iron; Accessories; Replacement Parts - Toolcraft To-8962 Mode D'emploi

5.7 Mains cable

Do not modify or repair mains supply components including mains plugs, mains cables, and power sup-
plies. Do not use damaged components. Risk of death by electric shock!
■
The mains outlet must be located near to the device and be easily accessible.
■
Never plug in or unplug the mains plug when your hands are wet.
■
Never pull the mains plug from the socket by pulling at the cable. Always pull it from the mains socket using the
intended grips.
■
Unplug the mains plug from the mains socket if you do not use the device for an extended period of time.
■
Disconnect the mains plug from the mains socket in thunderstorms for reasons of safety.
■
Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or put under mechanical stress.
■
Avoid excessive thermal stress on the mains cable from extreme heat or cold.
■
Do not modify the mains cable. Otherwise the mains cable may be damaged. A damaged mains cable can
cause a deadly electric shock.
■
Do not touch the mains cable if it is damaged.
– First, power down the respective mains socket (e.g. via the respective circuit breaker) and then carefully pull
the mains plug from the mains socket.
– Never use the product if the mains cable is damaged.
■
A damaged mains cable may only be replaced by the manufacturer, a workshop commissioned by the manufac-
turer or a similarly qualified person, so as to prevent any danger.
■
Ensure that cables are not pinched, kinked or damaged by sharp edges.
■
Always lay cables so that nobody can trip over or become entangled in them. This poses a risk of injury.

5.8 Soldering iron

■
Always place the soldering iron in the stand/holder if you do not use it.
■
Do not leave the soldering iron unattended if switched on.
■
Do not touch the hot soldering iron tip to prevent burns.
■
Always keep the soldering tip away from the power cord.
■
Switch the soldering iron off if you do not use it for extended periods.

5.9 Accessories

■
Accessories and components that are not compatible with the product can damage the product or result in haz-
ards. Only use the supplied components and accessories.

5.10 Replacement parts

■
Only use replacement parts designed for the product to prevent hazards.
18