Dimplex DF2624L-INT Manuel D'installation page 6

Remote Control - See Fig.2
The maximum range of use is
NOTE: It takes time for the receiver
transmitter.
NOTE: The reciever for the
the display, aim the remote
inputting commands.
Do not press the buttons
seconds for correct operation.
Battery Information - See Fig. 2
I . To activate the remote control remove
isolation strip at the base
is used to ensure your remote control reaches
charged.
2. To replace the remote
remote control, and follow the diagram embossed on the
remote control
3. Only use CR2025 or CR2032 size of batteries.
Fitting- See Fig. 3 & 4
IMPORTANT: If not using a Dimplex mantel, the fireplace
must be installed in an enclosure
MINIMUM dimensions(Figure
The firebox must be secured in place, using the L-Brackets
supplied with this product,
the steps shown in Fig. 4.
1. Select a suitable location
moisture and is at least I meter away
furniture and high traffic.
2. Store the fireplace in a safe,
dry and dust free location.
3. Clearance for air circulation
is provided by two spacers. DO NOT INSTALLFIREPLACE
DIRECTLY ON CARPET OR SIMILAR
RESTRICT AIR CIRCULATION.
a carpeted area, place
under the fireplace. Ensure that all feet rest securely on
this surface!
4. In some jurisdictions this appliance
a plug this is to comply with the local regulations.
instances this appliance
quailified installer and the means for disconnection
be incorporated in the fixed wiring in accordance
the local wiring rules.
5metres.
to respond to the
remote control is located
control in this direction
more than once within
the clear battery
of the remote control,
you fully
control battery, turn over the
with the following
3).
to fit these brackets please follow
that is not susceptible
from drapes,
beneath the fireplace
SURFACES WHICH
If installing the fireplace
a one-piece, solid flat surface
is supplied without
In such
must be installed by a suitabily
New Wall Construction
l. Select a suitable
moisture and
traffic.
in
when
2. Place the fireplace
it will look in the
two
3. Mark the desired
4. Use studs to frame
which
Option #1
The power
along the wall to an outlet near the fireplace.
Option #2
A new outlet
construction.
240 Volt outlet.
a 3-core type extension cord rated for a minimum of
10 Amps.
Existing Fireplace
1 . Seal all drafts
material to prevent any chimney debris from falling
onto the fireplace.
fireplace that is prone to dampness.
to
2. Cap the top of the chimney flue to prevent rain from
3. Plan your electric power supply.
4. The power
the front of the
outlet near the fireplace.
MAY
Installing Front Glass- See Fig. 5,6 & 7
in
NOTE: The outer glass is shipped seperate to the firebox.
1. Remove the three screws holding
in Fig. 5. and remove the metal trim.
2. Unpack the glass, ensure it is free from dust and finger
marks and slide in to position as shown in Fig. 6.
must 3. Position the metal
with with the three screws as per Fig. 7
location that is not susceptible
is away from drapes. furniture
in the desired location
room.
location on the floor.
an opening as per Fig. 3.
cord can be run from behind
can be installed inside
Plug the fireplace into a 10-13Amp/230-
If the cord does not reach you may use
and vents with a non-fibrous
Do not install into an existing
cord can run along
hearth to an
the side trim as shown
trim removed in step I, and secure
to
and high
to see how
the trim and
the framing
insulation