Remington RM40BST Manuel Du Propriétaire page 8

TRIMMER ASSEMBLY
ASSEMBLING TRIMMER/
EDGER
WARNING:
Do not operate trimmer/edger
without guard or handle
place.
Attaching Cutting Guard
and Edging Wheel
Remove five mounting
underside of cutting guard.
2. Place cutting guard over spool housing at
a slight angle. Push guard hack depressing
tabs toward front of cutting guard. (See
figure 4). Drop back of cutting guard into
place.
3. Slide cutting guard forward. (See figure
5)
4. Insert mounting screw into hole near-
est tabs in cutting guard. Tighten screw
firmly. (See Figure 6)
Inselt two mounting screws into holes at
5.
back of cutting guard. (See Figure 7)
6. Place edging wheel over remaining two
screw holes at front of cutting guard. At-
tach edging wheel using two mounting
screws. (See Figures 8 and 9)
Figure 4 - Placing cutting guard
ting head
in
Figure 5 - Slide cutting
screws taped to
Figure 6 - Insert
Figure 7 - Insert
Figure 8 - Placing
screw holes
over cut-
Figure 9 - Attaching
guard forward
mounting screw
two mounting screws
edging wheel over
edging wheel
8
ATTACHING ADJUSTABLE
FRONT HANDLE
Remove the knob and
handle (see Figure 10).
2. Place the handle on the trimmer/edger
shaft between the rear handle
collar. Snap handle onto shaft (see Figure
Insert bolt back into the front handle (see
3.
Figure 12).
3. Adjust handle to the most comfortable po-
sition and tighten the knob firmly. Do not
overtighten the knob. (See Figure 13).
Figure 10 - Removing knob and bolt from
handle
Figure 11 - Placing handle onto
Figure 12 - Inserting bolt into handle
Figure 13 - Tighten the knob
bolt from front
and shaft
shaft