Remington RM40BST Manuel Du Propriétaire page 7

Table des Matières
RECHARGEABLE
IMPORTANT
CHARGING
After normal usage, your battery pack
should be fully charged in 3 to 9 hours. If
the battery pack is run-down completely,
it may take up to 9 hours to become fully
charged. Your battery pack was sent from
the factory
in an uncharged condition.
For best performance charge battery until
red LED turns off. Allow
cool down 30 minutes before charging
after using the trimmer/edger.
hot battery placed in the charger will not
charge.
2.
DO NOT charge the battery pack in an
air temperature below 400F (4,5 oc) or
above 1050F (40,5 oc). This is important
and will prevent serious damage to the
battery pack. Longest life and best per-
formance can be obtained if battery pack
is charged when air temperature is about
750F (240C).
BATTERY
NOTES
3.
While charging, the charger may hum and
become
warm
condition
lem.
4.
If the battery pack does not charge prop-
erly
• Check current at receptacle by plugging
the battery to
in a lamp or other appliance.
Check to see if receptacle is connected
NOTE: A
to a light switch which turns power off
when you turn out the lights.
• Move charger and battery pack to a
surrounding
(4.50C) to 1050F (40,5 oc)
• If the receptacle and temperature are
0K, and you do not get proper charging,
call the Customer Service Department.
to touch.
This
is a normal
and does not indicate a prob-
air temperature
of 400F
7
5.
The battery pack should be recharged
when it fails to produce sufficient power
on iObswhich were easily done previously.
DO NOT CONTINUE
using product with
its battery pack in a depleted condition.
To prolong battew life. avoid leaving the
6.
battery pack on charger for extended pe-
riods of time (over 30 days without use).
Although
overcharging
is not a safety
concern. it can significantly reduce overall
battelY life.
7.
The battery pack will reach optimum per-
formance after being cycled 5 times during
normal usage. There is no need to run the
batteries down completely before mecharg-
ing. Normal usage is the best method of
discharging and recharging the batteries.
Table des Matières
loading

Table des Matières