Auto Restart - Lg Goldstar R1201E Manuel D'utilisation

Remote Control Operations
The remote control and control panel will look like those represented
MODE TIMER
POWER
Operation starts when this button is pressed and
stops when you pressthe button again.
(J
TEMPERATURE CONTROL
The thermostat monitors room temperatureto
maintan the desired temperature
The thermostat can be set between
The unit takes an average of 30 minutes to adjust
the room temperature by
OPERATION MODE
Selectcooling mode to cool the room,
Select energysaver mode for energysaving
operation.
AUTO BE-START
In failure of electric power, the unit runs as previous setting operation.
inserting the Remote Control Batteries
D
Push out the cover on the back of the remote control with your thumb
Pay attention to polarity and inserttwo new AAA 1.5V batteries.
Reattach the cover.
Nory-.t
: Do not use rechargeablebatteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the air
conditioneris not going to be used for an extendedperiod of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should not be
exposed to direct sunlight.
• Theremote control can be mounted on a wall using the mountable holder.
88 c
FAN
pow ER
SPEED
oc
SELECTOR
in the following pictures.
6
2
5
Select fan mode for basicventilating fan
operation.
Select dry mode for dry operation.
FAN SPEED SELECTOR
For increased power while cooling, select a
higher fan speed.
3 steps: High-+ Low * Med
ON/OFF TIMER
The timer can be set to start and stop the unit in
hourly increments(up to 12 hours).
REMOTE CONTROL
Operating Instructions
2
4
3
SENSOR
Owner's Manual 9