LG GoldStar R1201E Manuel D'utilisation page 19

4)
The cabinet should be installed with a very slight tilt
(about 1/2") downward toward the outside
(See Fig. 5).
Adjust the bolt and the nut of Sill Support (2)for
balancing the cabinet.
Attach the cabinet to the window stool by driving
the screws (Type B: Length 16mm (5/8 inch)
and below.) through the front angle into window
stool.
C) Pull e ach Frame C urtain O fully toeach window
sash track, and repeat step 2.
4)
Attach each Frame Curtain Cthe window sash using
screws O (Type C). (See Fig 6)
A CAUTION
: Do not drill a hole in the bottom
The unit is designed
approximately 1/2" of water in bottom pan.
There is no need to add
pan is dry.
Slide the unit into the cabinet (See Fig. 7)
A CAUTION
: For security purpose, reinstall screws
(Type A) at cabinet's
Cut the Foam-Strip D to the proper length and insert
betweenthe upper window sash and the lower
window sash. (See Fig. 8)
pan.
to operate with
water if the
sides.
Screw(Type
Screw(Type B)O
Sill Support@
Screw(Type A)
Power cord
Hardware Installation
Sill SupportO
Sash track
Front Angle
Fig. 5
Type CO
Fig. 6
Screw
Fig. 7
(Type A)
Foam-StripO
Fig. 8
Owner's Manual 19