LG GoldStar R1201E Manuel D'utilisation page 22

Hardware Installation
Cabinet installatipn
Open the window. Mark a line on the center of the
window stool between the side window stop
moldings.
oosely attach the sill bracket to the support
L
bracket using the carriage bolt and the lock nut
Attach the sill bracketto the window sill using the
screws (Type B).
Carefully place the cabinet on the window stool
and align the center mark on the bottom front with
the center line marked
(J Usin g the M- screwand the lock nut, a ttach the
support bracketto the cabinet track hole. Use the first
track hole after the sill bracket on the outer edge of
the window sill. Tighten the carriage bolt and the lock
nut. Be sure the cabinet
A CAUTION
: Do not drill a hole in the bottom pan.
The unit is designed to operate with
approximately 1/2" of water in bottom pan.
Pull the bottomwindow sash down behindthe Top
retainer bar until they meet.
1. Do not pull the window sash down so tightly
that the movement of Frame
Attach the cabinet to the window stool by driving
the screws (Type B) through the cabinet into
window stool.
2. The cabinet should be installed with a very slight
tilt downward toward
22 Room Air Conditioner
window stool
slants outward
curtan is restricted.
the outside.
S ill
Bracket O
Carria e
Bolt 9
Cabinet
Track hole
Support
Bracket@
Carriage bo t
and lock nut
Upper
Guide
Window sash
Upper Guide
Foam
-SealO
Cabinet
Frame curtain
Foam-PE@
Support
Bracket@
Lock nut@
Fig. 1
Machine screwgype D)
and lock nut
Outer edge
of window
O (TypeB)
Sill bracket
Fig. 2
Window stool
Frontangle
Fig. 3
Fig. 4