LG GoldStar R1201E Manuel D'utilisation page 15

WL Series
How to Install
To prevent vibration and noise, make sure the unit
is installedsecurely and firmly
Install the unit where the sunlight does not shine
directly on the unit.
The outside of the cabinet
at least 12" and there should be no obstacles, such
as a fence or wall, within 20' from the back of the
cabinet because it will prevent heat radiation of the
condenser.
Restrictionof outside air will greatly reducethe
cooling efficiencyof the air conditioner.
A CAUTION
: All side louvers of the cabinet
Install the unit a little slanted so the back is slightly lower than the front (about 1/2")
ThlS will force condensed
nstall the unit with the bottom
Window Requirements
NOTICE
: All supporting parts should be securedto firm wood,
masonry, or metal.
• This unit is designed for installation in standard double
hung windows with actual openingwidths from 27"
to 39".
• The top and bottom window sash must open sufficiently
to allow a clear vertical opening of 16" from the bottom
Of the upper sash to the window stool.
the Unit
must extend outward
must remain
water to flow to the outside.
about 30"-60" above
Cooled air
for
exposed to the outside
the floor level.
27" to 39"
1 6" min
(With frame curtain)
Interior wall
23 5/8" min.
(Without frame curtain)
Hardware Installation
Fence
Awning
Heat
radiation
About 1/2"
Over 20"
of the structure.
Stool
Offset
1/2" to 11/4"
Sill
Exterior
•
Owner's Manual 15