Roller Plus H-R Mode D'emploi page 39

Revision date:
13.10.2017
6.2. Environmental precautions
Do not allow to enter into surface water or drains. Do not allow to enter into soil/subsoil. Clean contaminated
articles and floor according to the environmental legislation.
6.3. Methods and material for containment and cleaning up
Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents). Treat the
recovered material as prescribed in the section on waste disposal.
6.4. Reference to other sections
See protective measures under point 7 and 8.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Advice on safe handling
Use personal protection equipment. Do not eat, drink or smoke when using this product. Provide fresh air. Handle
and open container with care. Conditions to avoid: generation/formation of aerosols.
Advice on protection against fire and explosion
No special measures are necessary.
7.2. Conditions for safe storage, including any incompatibilities
Requirements for storage rooms and vessels
Protect against: Frost. Keep away from heat. Protect against direct sunlight. Keep container tightly closed in a
cool, well-ventilated place.
7.3. Specific end use(s)
Observe technical data sheet.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
8.2. Exposure controls
Appropriate engineering controls
See chapter 7. No additional measures necessary.
Protective and hygiene measures
When using do not eat, drink, smoke, sniff.
Eye/face protection
Eye glasses with side protection.
Hand protection
Wear suitable gloves. Recommended glove articles: DIN EN 374. Suitable material: NBR (Nitrile rubber).
Breakthrough time (maximum wearing time): > 480 min (Thickness of the glove material: 0.4 mm). Breakthrough
times and swelling properties of the material must be taken into consideration. For special purposes, it is
recommended to check the resistance to chemicals of the protective gloves mentioned above together with the
supplier of these gloves. Barrier creams can help protecting exposed skin areas. In no case should they be used
after contact.
Skin protection
Protective clothing.
Respiratory protection
With correct and proper use, and under normal conditions, breathing protection is not required. When splashes
or fine mist form, a permitted breathing apparatus suitable for these purposes must be used. Suitable respiratory
protection apparatus: Filtering Half-face mask (DIN EN 149), e.g. FFA P / FFP3.
Environmental exposure controls
Do not allow to enter into surface water or drains.
Revision No: 1,9 - Replaces version: 1
Safety Data Sheet
according to Regulation (EC) No 1907/2006
Roller's Plus H+R
Article No.: 115607
GB - EN
Page 3 of 7
Print date: 11.12.2017