Yamaha R-S300 Mode D'emploi page 39

■ iPhone/iPod
The following messages may be displayed on the front panel display in certain situations.
Message
There is a problem with the signal path
Connect error
from your iPhone/iPod to the unit.
The iPhone/iPod being used is not
Unknown iPod
supported by the unit.
Your iPhone/iPod is properly placed in
Connected
the Universal Dock for iPod.
Your iPhone/iPod is properly placed in
the Wireless System for iPod and
connected with this unit via wireless
transmission.
Your iPhone/iPod is removed from the
Disconnected
Universal Dock for iPod.
Your iPhone/iPod is disconnected with
this unit via wireless transmission.
The wireless connection is poor.
Problem
This unit is not turned on.
When using the
Universal Dock for
The iPhone/iPod is not connected
iPod:
securely.
Your iPhone/iPod is
not being charged
even though it is
connected to the
Universal Dock for
iPod.
This unit is not turned on.
When using the
Wireless System for
The YID-W10 transmitter is not stationed
iPod:
securely in the YID-W10 receiver.
Your iPhone/iPod is
not being charged
even though the
YID-W10 transmitter
connected to your
iPhone/iPod is
stationed in the
YID-W10 receiver.
Status/Cause
Cause
Remedy
Turn off the unit and reconnect the Universal Dock
for iPod to the DOCK jack of the unit.
Remove your iPhone/iPod from the Universal Dock
for iPod and then place it back in the dock.
Connect an iPhone/iPod supported by the unit.
Place the YID-W10 receiver as far away from this
unit as possible.
Remedy
Turn on this unit or set it to standby mode.
Connect the iPhone/iPod securely to the Universal
Dock for iPod.
Turn on this unit or set it to standby mode.
Station the YID-W10 transmitter connected to your
iPhone/iPod securely in the YID-W10 receiver.
TROUBLESHOOTING
See
page
24
24
24
—
26
—
—
24
See
page
4, 8
—
4, 8
—
35
En