Connecting An Infrared Signal Receiver Or Yamaha Component To The Remote In/Out Jacks; Connecting Power Cable - Yamaha R-S300 Mode D'emploi

Connecting an infrared signal
receiver or Yamaha component to
the REMOTE IN/OUT jacks
An infrared signal receiver can be connected to the
REMOTE IN jack using a monaural 3.5 mm mini plug
cable as follows. In addition, Yamaha components that are
capable of transmitting and receiving remote control
signals can be connected to the REMOTE IN and
REMOTE OUT jacks.
Remote
control out
Infrared signal
receiver or Yamaha
component
• By connecting the remote control output jack of an
infrared signal receiver to the REMOTE IN jack, you
can control this unit using the remote control even if
this unit is placed in a rack or other location where the
remote control signals cannot reach.
• By connecting the remote control input jack of another
Yamaha component to the REMOTE OUT jack, you
can control the component using the remote control of
this unit or the Yamaha component.
y
Up to six Yamaha components can be connected in series using
the remote control input and output jacks.
Remote
control in
Yamaha component
(CD or DVD player, etc.)

Connecting power cable

Plug the power cable into the AC wall outlet after all other
connections are complete.
CONNECTIONS
To the wall
outlet with the
power cable
13
En