Dimplex Optimyst MPT80 Guide D'installation Et D'utilisation page 8

Installation
1
Fill the water tank
2
Plug in the stove and turn it on
3
Place the log set
8
Remove the water tank lid by turning it anti-clockwise,
and fill it with clean water.
When screwing the water tank lid back on, be careful
to not over tighten the lid.
Reinstall the water tank into the stove.
NOTE: Only fill the water tank with clean water.
!
This is necessary to produce the flame effect.
Plug the Optimyst stove power cord into
a 13 amp, 230-240 V outlet.
Turn on the power switch on the
cassette and press the standby button
on the stove.
NOTE: Ensure that the power cord
!
is not trapped under the Optimyst
stove as it could cause the cord to be
damaged.
Place the log set inside the stove for the finished
look.
MPT100LS model only: Add logs in the log storage
below if desired. Do not fill above the spacer bar.
www.dimplexfires.com