Remote Control Battery Replacement - Dimplex Optimyst Mpt80 Guide D'installation Et D'utilisation

Maintenance

Remote Control Battery Replacement

To replace the batteries:
1. Remove battery cover of the remote.
2. Correctly install two AA batteries in the battery holder.
3. Secure the battery cover.
Batteries must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling
advice in your area.
Cleaning
WARNING: Disconnect power and allow 10 minutes for the heater to cool before attempting any maintenance
or cleaning to reduce the risk of fire, electric shock or damage to persons.
WARNING: The Optimyst stove should not be operated with an accumulation of dust or dirt on or in the unit, as
this can cause a build-up of heat and eventual damage.
!
NOTE: Avoid spilling any water to prevent water damage to electronics.
1. Empty the water tank and thoroughly clean the cap
Water Tank
2. Add warm water and washing-up liquid, shake, and
3. Refill with clean water and tighten the cap.
1. Disconnect the transducer cable and set it aside
2. Use the brush to dislodge any calcium build up.
3. Rinse the transducer with water.
Tranducer
Note: The transducer is a consumable item and may
need to be replaced from time to time depending on its
usage, water quality and maintenance.
1. Remove the nozzle by pushing the tabs at the front
Sump 2. Gently lift out the sump, empty it, and clean with
3. Rinse thoroughly with clean water.
1. Unscrew the filter cover
2. Remove the air filter.
Air Filter
3. Rinse the filter and dry with a towel.
4. Reinstall with the coarse black side facing outward.
5. Refit the filter cover.
Use a soft clean duster to clean the surfaces of the
Surface Cleaning
Optimyst stove. Do not use abrasive cleaners.
Use a dry cloth to remove any dust build-up on the front
Heater Assembly
grille at the base of the Optimyst stove.
Servicing
Except for installation and cleaning described in this manual, an authorized service
representative should perform any other servicing.
14
and its seals with the supplied brush.
rinse thoroughly.
of the module.
warm soapy water using the supplied brush.
Air filter
www.dimplexfires.com