Assembly; Install Discharge Chute; Install Handle; Before Starting - Toro 38171 Manuel De L'utilisateur

PowerShift operation
Belt routing

Assembly

Note: Determine left and right sides of
snowthrower by standing in the normal
operating position.
Install Discharge
1. Position holes on sides of discharge chute over
hex bolts on sides of chute
discharge chute onto hex bolts with (2) washers
and (2) locknuts. While holding hex bolt heads
with a wrench (7/16), tighten locknuts securely.
Rotate discharge chute to the completely upright
2.
position. Secure rear of discharge chute with a
washer and locknut.
Install Handle (Fig. 3)
1. Position ends of upper handle on inside of lower
handlesand align holes. Secureupper handle to
lower handles using oval head bolts, curved
washers, and knobs. Position knobs and curved
washers on inside of handle
KNOBS SECURELY to prevent them from
loosening.
Note: Make sure the oval head bolts and
curved washers are aligned correctly as
shown in Figure 3 to prevent knobs
from loosening.
GB-8
o
Chute (Fig. 2)
handle. Secure
and TIGHTEN

Before Starting

DANGER
POTENTIAL HAZARD
• In certain conditions gasoline is extremely
flammable and highly explosive.
WHAT CAN HAPPEN
• A fire or explosion from gasoline can burn
you, others, and cause property damage.
HOW TO AVOID THE
Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is cold.
Wipe up any gasoline that spills.
Do not fill the fuel tank completely full.
Add gasoline to the fuel tank until the level
is 1/4" to 1/2" (6 mm to 13 mm) below the
bottom of the filler neck. This empty space
in the tank allows gasoline to expand.
Never smoke when handling gasoline, and
stay away from an open flame or where
gasoline fumes may be ignited by a spark.
Store gasoline in an approved container
and keep it out of the reach of children.
Never buy more than a 30-day supply of
gasoline.
HAZARD