Using The Remote Controller - Mitsubishi Electric QAHV Série Manuel D'installation & D'instructions

[3] Using the Remote Controller

<1> Power ON/OFF
During operation
During stoppage
<2> Operation mode and set temperature settings
Operation mode setting
Button operation
Unit1
F1 F2 F3
Set temperature setting
Button operation
Unit1
③
②
F1 F2 F3
Unit1 FRI
Press the [ON/OFF] button.
Next
The ON/OFF lamp will light up in green, and the operation will start.
Unit1 FRI
Pressing the [ON/OFF] button brings up a confirmation screen. When it appears,
press the [F3] button.
Next
The ON/OFF lamp will come off, and the operation will stop.
Press the [F1] button to go through the operation modes in the order of "Mode1,
FRI
Mode2, and Mode3.
Select the desired operation mode.
Mode1
Next
The number of modes can be set to the value which is smaller than the setting
value of Item code 1507 (refer to page 44).
F4
Press the [F2] button to decrease the set temperature, and press the [F3] button
FRI
to increase.
The temperature can be set to the value which is equal or smaller than the setting
value of Item code 9 (refer to page 28) or Function setting No. 021 (refer to pages
①
76 and 77).
Next
① Set water temperature display
The currently set thermo-OFF temperature is displayed.
F4
② Control water temperature display
The thermistor temperature to be used for thermo-OFF is displayed.
③ Number of units in operation/total number of units
The number of units currently in operation and the total number of units are
displayed.
"
Mode2 Mode3
GB-69