Joerns Oxford Calibre Manuel De L'utilisateur page 6

Oxford
®
Calibre
3. Tighten the M10 screws to secure each leg using a socket and torque wrench.
Ensure the screws are secured firmly. It is recommended to tighten these to 10Nm
Avoid trapping fingers. Keep fingers away from the end of the leg when inserting into the leg
socket. Keep fingers away from the front castor bracket during assembly of the legs to the base.
4. Lift the Calibre onto its castors.
NOTE: On a flat surface, all 6 castors must be in contact with the floor.
The Calibre is extremely heavy, a minimum of 2 people will be required to lift the hoist.
5. Insert the two bushings into the outside of the mounting brackets on either side of the boom.
Lift the boom and position the actuator so that the upper fixing hole align with the mounting
bracket holes on the boom.
6
WARNING
WARNING
WARNING
English