PRO-POINT 8570269 Manuel D'utilisation page 10

8570269
15 pc Angled Air Sanding and
Surface Preparation Kit
INSTALL AIR CONNECTOR
V1.0
Prepare a standard 1/4 in. NPT male air connector (sold
separately) for use with your tool.
1. Wrap the external threads of the male connector
with sealant tape.
a. Wrap tape in a clockwise direction so it will
not unravel.
b. Do not tape all the threads. Leave several
leading threads unwrapped for
easier alignment.
2. Screw the connector into the tool's air inlet and
tighten with a wrench until snug.
3. Run compressor at a low volume and check the
connection for air leaks. Do not use the tool until all
air leaks are repaired or the faulty component
is replaced.
OPERATION
ATTACHING SANDING DISCS
Selecting the correct size and type of abrasive grit is
extremely important in achieving a high quality sanded
finish. Aluminum oxide, silicon carbide and other synthetic
abrasive are best for power sanding. To produce the best
finish possible, start with a coarse grit sanding paper and
gradually change to finer and finer grit sandpapers. A
final sanding with a well-worn fine sandpaper will produce
a professional looking finish that in many cases will not
need hand sanding.
1. Disconnect the tool from the air source.
10 For technical questions call 1-800-665-8685