Simplified Uk/Eu Declaration Of Conformity Regarding Radio Equipment; Regulations; Scope Of Delivery; Technical Data - Bosch Climate Room Control Crc R-1 Notice D'installation Et D'utilisation

2.3 Simplified UK/EU Declaration of conformity
regarding radio equipment
Bosch Thermotechnik GmbH hereby declares, that the product
Climate Room Control described in these instructions complies
with the Directive UK S.I. 2017/1206 (UK) 2014/53/EU.
You can request the complete text of the UK/EU Declaration of
Conformity from the UK address indicated in this document.
2.4

Regulations

In order to ensure installation and operation of the product in
accordance with the regulations, please observe all the
applicable national and regional regulations as well as all
technical rules and guidelines.
You can find a list of the most relevant British and European
directives and regulations in the table below.
EU legislation
Electromagnetic
Compatibility - Directive
2014/30/EU
Low Voltage Directive 2014/
35
Radio Equipment -
Directive 2014/53/EU
Pressure Equipment -
Directive 2014/68/EU
Gas Appliances -
Regulation (EU) 2016/426
Machinery Directive 2006/
42/EC
Ecodesign Directive 2009/
125/EC
Energy Labelling Regulation
(EU) 2017/1369
Restriction of the Use of
certain Hazardous
Substances in Eletrical and
Electronic Equipment (RoHS)
- Directive 2002/95/EC
European Directive 2012/
19/EC on old electronic and
electrical appliances
Table 26
Climate Room Control – 6721841498 (2025/07)
UK legislation
Electromagnetic
Compatibility Regulations
2016
Electrical Equipment (Safety)
Regulations 2016
Radio Equipment Regulations
2017
Pressure Equipment (Safety)
Regulations 2016
Regulation 2016/426 on gas
appliances as brought into UK
law and amended
Supply of Machinery (Safety)
Regulations 2008
The Ecodesign for Energy-
Related Products Regulations
2010
Energy Labelling Regulation
(EU) 2017/1369 (as retained
in UK law and amended)
The Restriction of the Use of
Certain Hazardous
Substances in Eletrical and
Electronic Equipment
Regulations 2012
(UK) Waste Electrical and
Electronic Equipment
Regulations 2013 (as
amended)
2.5

Scope of delivery

The appliances are shown as an example and deviations are
possible.
The scope of delivery is shown in Fig. 1.
[1] wired controller
[2] Communication cable
[3] Fixing materials
[4] Button battery
[5] Set of printed documents for product documentation
[6] Magnet ring
[7] Extension cable (6 m)
The button battery enables the time to be saved following a
power failure. If the time is not displayed correctly following a
power failure, the button battery is empty.
2.6

Technical data

Input power voltage
Permissible ambient temperature
T
amb
Permissible relative humidity
Table 27
3

Installation

3.1

Prior to installation

▶ Carefully read the technical documentation of the indoor
unit, outdoor unit and other system components and
determine a suitable installation location.
▶ The ambient temperature at the installation location should
be in the following range: −5...43 °C.
▶ The relative humidity at the installation location should be
in the following range: 40...90 %.
▶ Do not install in locations where it is likely to come into
contact with heavy fuel oil, steam or sulphur gas.
▶ Observe the dimensions of the wired room controller (
Fig. 2).
▶ Install it far from heat sources.
▶ Ensure that there is air circulation.
Installation
CRC R-1
12 V DC
−5...43 °C
40...90%
55