Troubleshooting - AVG AVP286PPS Instructions D'installation Et Guide De L'usager

steel to prevent any unattractive crisscross scratching patterns.
IMPORTANT
When cleaning only use mild detergents. Avoid using harsh cleaning chemicals, strong household detergents
or abrasive products, as they will affect the appliance appearance and potentially remove any printing of
artwork on the control panel. Failure to follow these instructions will void the warranty.
GREASE FILTERS (micro-holes & baffle)
The filters should be hand-wash as they are not dishwasher safe. Soak them for about 3 minutes in water with
a grease-loosening detergent then scrub gently with a soft brush. Do not apply too much pressure, to avoid
any damage. Filters should be washed separately from kitchen utensils. Do not to use any kind of rinse aid.

6.TROUBLESHOOTING

Fault
Light on, but motor does
not work
Light does not work,
motor does not work
Oil leakage
Lights not working
Insufficient suction
The range hood is
leaning
IMPORTANT: Any electrical repairs made to this appliance must conform to your local,
provincial and federal laws. Please contact the service center before undertaking any repairs.
Always disconnect the unit from the power source before servicing or maintaining.
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Power cord loose or disconnected
Examine valve /outlet verify that are
tightly sealed
Leakage from exhaust duct and cover
Broken/Faulty LED lamps
The distance between the range
hood and the cooking surface is too
high
The fixing screws are not tight
enough
Solution
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit cord to power outlet. Switch
power outlet on.
Take down the check valve and seal
with sealant.
Take exhaust duct down and seal.
Replace LED lamps as per instructions.
Reinstall the range hood to the correct
distance.
Tighten the hanging screws and level
the hood correctly.
29