Publicité
nOperations after first power-on
Initial Setting of USB FUNCTIONALITY
USB Hub/Type-C function/[USB LAN] in OSD menu are disabled as the default condition set at the
factory and in the product's firmware; performing a FACTORY PRESET returns the function to its
default disabled condition for reduced power consumption.
When turning on the monitor for the first time or after FACTORY PRESET, the USB FUNCTIONALITY
message is shown. Select a setting from below. The [USB LAN] settings in OSD menu need to be
changed if you use the LAN terminal.
OFF:
USB FUNCTIONALITY continues to be disabled.
AUTO:
USB FUNCTIONALITY is used when the monitor power is ON.
ON:
USB FUNCTIONALITY is used when the monitor power is ON and OFF.
Touch "<" and ">" keys for setting then touch "MENU/EXIT" key to close the message.
After this Initial Setting, another selection is possible by OSD menu.
Model
Product
Power Supply
Operating
Temperature
Humidity
Altitude
Storage
Temperature
Humidity
Power Consumption
(Normal operation*
/
1
Standby mode*
/Off mode)
2
Dimensions*
With stand
3
Without stand Approx. 531.5 mm (W) x 47.6 mm (D) x 347.8 mm (H)
Weight
*
: Factory setting.
1
*
: When no signal inputs. Time for power management function: Less than 1 min.
2
*
: Excluding protrusions.
3
EA242W
LCD MONITOR
AC 100 - 240 V, 1.40 - 0.70 A, 50/60 Hz
5 ~ 35 °C/41 ~ 95 °F
20 ~ 80% (no condensation)
≤ 5000 m
-10 ~ 60 °C/14 ~ 140 °F
10% ~ 85% (no condensation)
118 W
19 W/0.30 W/0.25 W
Approx. 531.5 mm (W) x 250.0 mm (D) x 365.3 mm - 515.3 mm (H)
20-15/16 inch (W) x 9-13/16 inch (D) x 14-3/8 inch - 20 5/16 inch (H)
20-15/16 inch (W) x 1-7/8 inch (D) x 13-11/16 inch (H)
Approx. 4.2 kg (9.3 lbs) (monitor only)
Approx. 6.7 kg (14.8 lbs) (with the stand attached)
English-11
EN
Publicité
