Publicité
This equipment is designed to be used in the condition of the power cord connected to the earth.
If the power cord is not connected to the earth, it may cause electric shock. Please make sure the
power cord is connected to the wall outlet directly and earthed properly. Do not use a 2-pin plug
converter adapter.
MUST BE
EARTHED
Please install the product in accordance with the following information.
When transporting, moving, or installing the product, please use as many people as necessary to
be able to lift the product without causing personal injury or damage to the product.
Please refer to the instructions included with the optional mounting equipment for detailed
information about attaching or removing.
Do not cover the vents on the product. Improper installation of the product may result in damage to
the product, an electric shock or fire.
Do not install the product in the locations below:
• Narrow spaces, and poorly ventilated spaces.
• Near a radiator, other heat sources, or in direct sunshine.
• Continual vibration areas.
REQUIRED
• Humid, dusty, steamy, or oily areas.
• An environment where there are corrosive gases (sulfur dioxide, hydrogen sulfide, nitrogen
dioxide, chlorine, ammonia, ozone, etc.).
• Outdoors.
• High-temperature environment where humidity changes rapidly and condensation is likely to
occur.
Do not mount the product in any configuration or position not described in the OPERATION
MANUAL.
Please check the Specifications for the available Tilt range when installing the product.
Prevent tipping and falling for earthquakes or other shocks.
To prevent personal injury or damage to the product caused by tipping over due to earthquakes or
other shocks, make sure to install the product in a stable location and take measures to prevent
falling. The measures to prevent falling and tipping are intended for reducing the risk of injury, but
may not guarantee the effectiveness against all earthquakes.
• The product must be mounted to an approved flexible arm (e.g. TUEV GS mark) or stand that
supports the weight of the product to prevent damage and personal injury that could result from
the product tipping over or falling.
• Only use the screws that were removed from the product's stand or the specified screws to avoid
REQUIRED
damage to the product or the stand.
• Please tighten all screws (Recommended Fasten Force: 98 - 137 N•cm) when installing the
product to a flexible arm or stand. A loose screw may cause the product to fall, causing damage
to the product or personal injury.
• Attaching the flexible arm should be performed by two or more people if the product cannot be
placed face-down on a flat surface for installation.
WARNING
English-4
Publicité
