Publicité
5. SETTINGS
5.1. SETTING FANSPEED
1. Select the mode that you want to adjust: Cooling / heating
2. the unit runs at comfort speed.
3. hold down [Mode] and [-] simultaneously until the first 4 LEd's are flashing.
4. Short press [-] or [+] to adjust the preset speed.
50%
55%
60%
65%
70%
75%
80%
85%
default factory setting of the fan speed is selected depending on the device's length in order to guarantee the sound levels..
5. after 30 seconds, the new settings are automatically saved and the device returns to the selected mode.
5.2. ADJUSTING THE WATER TEMPERATURE
Adjusting the maximum water temperature for cooling
by reducing the water temperature setting, the unit will
start later. if the water temperature is set higher, the unit
will start sooner.
1. Put the device in the cooling mode
2. hold down the [Mode] and [+] simultaneously until the
last 4 LEds start flashing.
52
15 sec
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Strada hybrid MM - tPt/b | MaNUaL | 2025.05.28 | V.3.03
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
Adjusting the minimum water temperature for heating
by increasing the water temperature setting, the unit will
start later. if the water temperature is set lower, the unit
will start sooner.
in combination with a heat pump, it may be necessary
to reduce the water temperature.
1. Put the device in heating mode
2. hold down the [Mode] and [+] simultaneously until the
last 4 LEds start flashing.
15 sec
90%
95%
100%
105%
110%
115%
120%
Publicité
