Assembly; Default Setting; Explanation Of Functions; Setting Mode - Becker Centronic SensorControl SC431 Notice D'utilisation

Operating Instructions
Note
Before installing in the position required, check that the transmitter
and receiver are functioning properly.
The device can be easily fi tted onto any fl at windowpane glass.
Before fi tting the unit to the inside of the window, please clean the pane care-
fully.
Encoding switch setting:
1. Upper position
2. Lower position
3. Lower position
4. Lower position
Function of the SC431
The SC431 can help protect your plants and furniture from the intense rays of
the sun. When the preset sun threshold is exceeded, your shutter/sun protec-
tion system will automatically be adjusted down until the SC431 is shaded. The
system will then come to a halt and readjust itself until the light sensor is un-
covered.

Setting mode

In the setting mode the sun and twilight thresholds can be adjusted with the help
of the control light.
The threshold values are indicated by the control light as follows:
Control light
Sun protection function /
Twilight function
18

Assembly

Default setting

Sunlight function ON
Twilight function OFF
Broken glass function OFF
Setting mode OFF

Explanation of functions

Green
Threshold
exceeded
Red Yellow
Threshold not Threshold identical
reached to actual value