Cembre HT131-U Notice D'utilisation Et Entretien page 5

FIG. 4
ACCESSORIES
ACCESSOIRES
ZUBEHÖR
ACCESORIOS
ACCESSORI
33
98
34
32
30
28
96
28
93
FIG. 5 DIES REPLACEMENT / INSERTION DES MATRICES / EINRASTEN PRESSEINSATZE
INSERCIONDE LAS MATRICES / INSERIMENTO MATRICI
AU130-... Adaptateur Adapter Adaptador Adattatore
Adaptor AU130-... AU130-... AU130-... AU130-...
Die Matrice Matrize Matriz Matrice
Rounding Matrice de Runddrück Preredon- Prearroton-
set mise au rond Set deador
Indentor Poinçon Stempel Punzón Punzone
AC130-P Adaptateur Adapter Adaptador Adattatore
Adaptor AC130-P AC130-P AC130-P AC130-P
33
34
32
30
28
95
94
92
39
3.3) Crimping
– Continue operating the moveable handle (53). The tool will automatically change over
to the high pressure stage. The ram will advance until the dies meet.
– It is recommended to continue pumping until the maximum pressure valve is activated
and a "click" is heard.
3.4) Dies re-opening
– Rotate main handle to release position
Completely close handles and the die will retract.
datore
3.5) Rest setting
– Completely retract the ram as § 3.4.
– Close handles and rotate main handle to rest position
will be locked.
– Store the tool in the plastic case.
4. CRIMPING OF CONNECTORS ON COPPER CABLES
4.1) Connector crimping
– Fit adaptor AU130-C (see § 4.2).
– Select the appropriate die set for the connector.
– Insert die set in to upper and lower die holders (see § 4.3).
98
– Insert the conductor in the connector.
– Position the connector between the dies and ensure the correct location of the crimp.
– To crimp connector continue as § 3.2.
4.2) Adaptor assembly
91
Insert the AU130-C (90) adaptor in the guides on the U-fork (33) until securely located, with
the grooves on the adaptor corresponding to the locators (34) on the U-fork head (33).
Remove the adaptor by pushing the adaptor off the locators and sliding from the head.
4.3) Dies assembly
4.3.1) Press release button (86) and insert the upper die (88) into the AU130-C adaptor
(90) until secured by the die retaining pin (87).
To remove the upper die, press the release button (86) and slide the die from the
adaptor (90).
4.3.2) Press the release pin (30) and insert the lower die (89) into the seat on the ram
(28) until secured by the pin (32). To facilitate this operation an advancement of 3-4 mm
(0.12 - 0.16 in.) of the ram (28) is suggested. To remove the die press the release pin (30)
and slide the die from the ram.
4
ENGLISH
.
; the moveable handle
(Ref. to Fig. 2 and 3)