CLEANING THE DROP COLLECTION
TRAY AND THE USED CAPSULE
DRAWER
The drop collection tray must be cleaned
every 2-3 days.
The used capsule drawer warning light
comes on to indicate that the drawer is full and,
therefore, must be emptied and fitted back into
place again.
Lift and lower the lever, to eject the last capsule
supplied.
To take the used capsule container drawer off,
first remove the drop collection tray and the
grid, then put your fingers inside the drawer
slot.
The machine will emit an acoustic signal
inform that the capsule collection tray has been
removed.
When the machine is set to the LOW POWER
mode, the machine will reset the count of the
inserted capsules if the drawer is taken off over
more than 5 seconds.
MAINTENANCE AND CLEANING
to
Remove the drop collection tray and the used
capsule container
Empty the used capsule drawer and the fluids
found in the drop collection tray.
Used capsule
container
Drawer
Grid
Wash all the components with cold or warm
water, then dry and fit them back into correct
place.
All the components can be washed by using a di-
shwasher.
Regularly check that the drop collection tray
is not full, so as to prevent fluid leakage.
EN
Drop collection tray
57