Technical Data; Assembly; Charging The Battery Pack - Bosch Active Line PowerPack 400 Notice Originale

English–7

Technical Data

Lithium-ion battery pack
Article number
– Standard battery pack
– Rack-type battery pack
Rated voltage
Rated capacity
Energy
Operating temperature
Storage temperature
Permitted charging temperature range
Weight, approx.
Degree of protection
This device is in compliance with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device must not cause harmful interference, and
(2) this device must accept any interference that is received, including interference that may cause undesired operation.
This device is in compliance with CAN ICES-3(B)/NM B-3(B).

Assembly

 Put the battery pack down only on clean surfaces. In
particular, avoid getting the charge socket and the con-
tacts dirty, e.g., with sand or soil.
Checking the Battery Pack Before Using for the
First Time
Check the battery pack before charging it or using it with
your eBike for the first time.
To do this, press the On/Off button 4 to switch on the bat-
tery pack. If no LED for the charge-control indicator 3 lights
up, then the battery pack may be damaged.
When at least one of the LEDs, but not all, for the charge-
control indicator 3 is lit, then fully charge the battery pack
before using it for the first time.
 Do not attempt to charge or use a damaged battery
pack. Please contact an authorized Bosch eBike dealer.

Charging the Battery Pack

 Only use the Bosch charger provided with your eBike
or an identical original Bosch charger. Only this
charger is matched to the lithium-ion battery pack used
in your eBike.
Note: The battery pack is supplied partially charged. To
ensure full battery pack capacity, completely charge the
battery pack in the charger before using it for the first time.
0 275 U07 XPX | (8.5.17)
PowerPack 400
0 275 007 524/538
0 275 007 525/526
V=
Ah
Wh
°F
°F
°F
lb
IP 54 (dust and splash water
To charge the battery pack, read and follow the operating
instructions for the charger.
The battery can be charged at any level of charge. Interrupt-
ing the charging process does not damage the battery pack.
The battery pack is equipped with a temperature control in-
dicator, which enables charging only within a temperature
range between 32 °F and 104 °F.
 CAUTION: Do not connect the battery pack to the
charger until it has reached the permissible charging
temperature.
Charge-control Indicator
When the battery pack is switched on, the five green LEDs
for the charge-control indicator 3 indicate the charge con-
dition of the battery pack.
Here, each LED indicates approx. 20 % capacity. When the
battery pack is completely charged, all five LEDs light up.
The charge-control for the switched on battery pack is also
indicated on the display for the on-board computer. Read
and follow the operating instructions for the drive unit and
the on-board computer.
36
11
400
+23...+104
+14...+140
+32...+104
5.5/5.7
IP 54 (dust and splash water
protected)
When the battery pack is not within the
charging temperature range, three
LEDs of the charge-control indicator 3
flash. Disconnect the battery pack from
the charger until its temperature has ad-
justed.
PowerPack 500
0 275 007 533/534
0 275 007 535/536
36
13.4
500
+23...+104
+14...+140
+32...+104
5.7/6.0
protected)
Bosch eBike Systems