Adjusting The Height; Placement Of Dishwasher Into The Opening - Bertazzoni Dw60S3Iapsp Manuel D'installation

INSTALLATION

PLACEMENT OF DISHWASHER INTO THE OPENING

Now place the dishwasher into the opening and get ready
to connect all hoses and electrical connections.
1) Connect the inlet hose to the cold water supply.
2) Connect the drain hose.
3) Connect the power cord.
4) Place the dishwasher into the cabinet.
CAUTION
Make sure that all hoses are pulled through
the side opening of the cabinet, that no
hoses are kinked and that all slack is taken
out as shown in the figure.

ADJUSTING THE HEIGHT

1) Keep the front feet at the minimum height before and
while positioning the dishwasher into the cabinet cutout.
2) Adjust the front foot level with a slot screwdriver to
stabilize the dishwasher and raise it to the enclosure
height.
3) Adjust the rear foot level with a Phillips screwdriver to
balance and raise the dishwasher to the enclosure
height.
The rear foot is located in the centre front at the base of the
appliance.
NOTE
Fig. 18
Make sure the dishwasher is plumb and
note that the dishwasher can be placed
with
countertop.
The dishwasher must be level to ensure proper dish rack
operation and washing performance.
Place a spirit level on door and basket rail inside the tub, as
illustrated, to check that the dishwasher is level.
Level the dishwasher by adjusting the three levelling points
individually.
a small clearance under the
Fig. 19
21