Publicité
62
ADJUSTING THE FILTER-HOLDER SUPPORT
The filter-holder support has been designed to work with the different holders found on the most
widespread coffee machines on the market.
Using a medium size Phillips screwdriver, slacken the support retaining screw, adjust its height and
then tighten the screw again (see Fig. 21).
The optimum adjustment is the one that supports the filter-holder in a perfectly horizontal position.
Module with start button
Never operate without hopper and lid in
place.
Make sure that shutter is completely
open (to the last click) (see Fig. 22).
When the grinder is not to be used during the time
when the business is closed, it should always be
switched off with the main switch.
Put only coffee beans in the hopper, not
ready-ground
substances.
Fig. 21
WARNINGS AND SUGGESTIONS
coffee
or
other
Module with load cell
GB
Fig. 22
Publicité
