Publicité
To install:
Twist open the clamp and insert the blade as
far as it will go. Once released, the blade will be
firmly held in place. Pull the blade to make sure
it is securely clamped.
To remove:
Twist open the clamp and pull the blade out.
WARNING:
The blade may be hot after use. Make sure it is
completely cooled down before touching it.
BATTERY PACK
NOTE:
Prior to installation, lock the trigger using the
trigger lock to avoid an unintentional start.
To install:
Align and slide the battery pack to the docking
port until it is locked in place.
To remove:
Press the unlock button and slide the battery
pack out.
WWW.SENIXTOOLS.COM
OPERATION
WARNING:
Always wear eye, hearing, and hand protection
to reduce the risk of injury when operating the
tool. Keep all parts of your body away from the
rotating bit.
WARNING:
Before cutting any type of material, be sure it
is firmly clamped to prevent slipping.
WORKPIECE AND WORK
AREA SET UP
1.
Designate a work area that is clean and
well-lit. The work area must not allow
children or pets to prevent distraction and
injury.
2.
Secure loose workpieces using a vise
or clamps to prevent movement while
working.
3.
There must not be objects, such as utility
lines, nearby that will present a hazard
while working. This is especially critical for
plunge cuts.
4. Using a glove, push blade clamp all the way
back. The workpiece must be thinner than
the minimum blade extension.
PVC Pipe
9 - EN
Publicité
