Publicité
Suspected malfunctions are often due to causes that the users can fix themselves. Therefore,
check the product using this section. In most cases the problem can be solved quickly.
PROBLEM
Product does not
start
Tool operates
slowly
Performance
decreases
over time
Excessive noise
Overheating
EN - 14
TROUBLESHOOTING
POSSIBLE CAUSE
The switch trigger is locked
Battery pack not properly attached
Battery pack completely
discharged
Forcing tool to work too fast
Battery power is too low
Blade is dull or damaged
Battery pack reaches its life cycle
Internal damage or wear (bearings,
for example)
Forcing tool to work too fast
Blade dull or damaged
Blocked motor housing vents
SOLUTION
Unlock the switch trigger by
trigger lock
Attach properly
Charge the battery pack
Allow tool to work at its own rate
Charge the battery pack
Keep blades sharp. Replace with a
new one if necessary
Replace with a new one
Have technician service tool
Allow tool to work at its own rate
Keep blades sharp. Replace as
needed
Blow dust out of motor using
compressed air
WWW.SENIXTOOLS.COM
Publicité
