Publicité
NOTE:
Charge the battery at an ambient temperature
range of 32°F - 104°F (0°C - 40°C).
1.
Charge the Lithium-Ion battery pack only
with the correct charger.
2.
Connect the charger to a power supply. The
LED indicator on the charger will turn red.
3.
Align the raised ribs of the battery pack
with the slot in the charger.
4.
Insert the battery pack into the charger.
The LED indicator on the charger will turn
green and begin to flash.
5.
The charger will communicate with the
battery pack to evaluate the condition of
the battery pack.
6.
The battery pack is fully charged when all
four of its LEDs are fully lit. Disconnect the
power supply from the charger. Remove the
battery pack from the charger.
CHARGING INDICATOR
Press the capacity indicator button on the
battery pack to check current charge level.
Capacity Indicator
EN - 12
Button
Lights
Fully Lit
Off
Blinking
WARNING:
All four lights blinking in sequence may
indicate a battery malfunction.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool
stops automatically. In this situation, let the
power tool/battery cool before turning the tool
on again.
OVERDISCHARGE
PROTECTION
When the battery capacity is below a safe
level, the tool stops automatically. If this
occurs, remove the battery from the tool and
charge the battery.
MAINTENANCE
WARNING:
Only perform cleaning and maintenance work
according to these instructions!
All further work must be performed by a
qualified specialist!
Status
75% - 100%
50% - 75%
25% - 50%
5% - 25%
< 5%
(Needs to be
charged)
WWW.SENIXTOOLS.COM
Publicité
