Publicité
WARNING:
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure the trigger is locked and the battery
pack is removed before performing any
procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL
FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration occurs, have the
problem corrected before further use.
There are no user-serviceable parts in your
power tool.
If any of the following conditions are found,
stop using it and send it to the authorized
service center for repair:
•
Leaking, swollen, or cracked battery pack
•
Loose hardware
•
Misalignment or binding of accessories.
•
Cracked or broken parts.
•
Any other condition that may affect its safe
operation.
CLEANING
1. Clean dust and debris from air vents.
2. Keep the handle clean, dry, and free of oil
or grease.
3. Make sure the clamp is free of chips and
sawdust.
4. Remove stubborn dirt from housing with
high-pressure air (max. 3 bar).
5. Never immerse your tool in liquid or allow a
liquid to flow inside them.
NOTE:
Do not use chemical, alkaline, abrasive, or
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.
TRANSPORTATION
1. Only carry by its handle.
2. Protect from any heavy impact or strong
vibrations which may occur during
transportation in vehicles.
3. Secure to prevent it from slipping or falling
over.
WWW.SENIXTOOLS.COM
STORAGE
1. Clean thoroughly as described above.
2. Store in a dark, dry, frost-free, and well-
ventilated area that is inaccessible
to children. Store the battery within a
temperature range of 32°F - 77°F (0°C -
25°C).
3. Use the original package for storage or
cover it with a suitable cloth to protect it
against dust.
NOTE:
To prolong battery life, store the battery
pack separately from the tool in a 30% - 50%
charged condition. It's recommended to have
your battery pack charged at least every 6
months.
DISPOSAL
Waste products should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice. Chips or sawdust may be produced
by the tool during operation, users should clean
these objects to protect the environment.
Electrical products should not be
discarded with household products.
Used electrical products must be
collected separately and disposed
of at collection points provided for
this purpose. Talk with your local
authorities or dealer for advice on
recycling.
13 - EN
Publicité
