Publicité
Vercise™ Deep Brain Stimulation Systems
Impedances
You can use the Remote Control to check impedances.
Clinician Menu:
From the
1. Select
Impedances. An impedance measurement is taken and the Impedances screen is
displayed.
When an impedance measurement is taken, impedances are assessed between a Contact and the
case (monopolar), and between pairs of Contacts (bipolar). A green square indicates that impedance is
within the acceptable range. A yellow dot with a question mark indicates that impedance is outside of
the acceptable range.
Monopolar impedance values can be displayed by pressing the Down Arrow
Impedances screen.
2. Select
Measure to check impedances again.
Back to go back to the Clinician Menu.
3. Select
Remote Control 3 Instructions for Use
92753326-04
20 of 203
button from the
Publicité
