Care And Storage; Technical Specifications; Disposal - Beurer FB 30 Mode D'emploi

• Check the device, power supply and cables for damage.
• Before you plug in the foot bath, fill it up to the fill-level mark (approx 6 cm full) with either warm or
cold water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.
Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the device. To do this, press the function button [2].
The vibration massage, bubble massage and maintains water temperature are started simultaneously.
The infrared light dots are activated by pressing again.
Press the function button [2] again to turn off all functions.
Pedicure attachment
The pedicure attachment in the middle can be used to remove calluses and can be removed for
cleaning.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
• A heater is fitted underneath the feet support. Warm water can be kept warm for a longer
length of time by switching on the heater. The heater is not suitable for heating cold water. To
achieve optimum results, it is recommended that the massage lasts no longer than 40 minutes.
After use, empty the water using the narrow side of the foot bath.

6. Care and storage

After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming house-
hold cleaner, e.g. neutral vinegar.
To dry out the air line after cleaning, switch on the bubble setting for approximately 10 seconds.
Drops of water emerging from the bubble bar can be wiped away with a cloth.
Note
• Do not allow water to penetrate the interior of the footbath.
• Store the footbath in its original packaging in a dry area. To do so, fold the foot bath together
again.
• Do not leave it open for an extended period.

7. Technical specifications

Mains connection 220-240 V~ 50/60 Hz 60 W

8. Disposal

For environmental reasons, do not dispose of the device in the household waste at the
end of its useful life. Dispose of the unit at a suitable local collection or recycling point.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please contact the local authorities
responsible for waste disposal.
12