Operation; Care And Storage - Beurer MG 204 Mode D'emploi

7. Operation

Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• D o not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• S witch on the massage device with the button. Select the area which you wish to massage.
1. full back
2. lower back
3. upper back
The LED lamp indicates the massage region set.
• You can activate the heat function of the massage heads by pressing the heat button [3]. The heat LED
lights up red during this process.
• The Shiatsu massage unit with rotating massage heads slowly moves upwards from the starting position
in the lowest region of the back and moves up and down in the massage region set. Application only at a
single point is not possible, as the rotational movement and the displacement up and down are coupled.
• The automatic switch-off function is activated with selection of the massage region and is preset to 15 min-
utes. You can set the automatic switch-off function to 5, 10 or 15 minutes by pressing the timer button.
Please note that changing the timer setting makes the timer start to count again from the beginning. To
avoid overheating the device, select the maximum massage duration at the beginning of the massage and
do not change it again during the massage.
• Do not use the massage device for longer than 15 minutes. The massage can be finished at any time by
pressing the button. Please note that on switching off, the Shiatsu massage unit firstly returns to the
starting position at the lowest region of the back. Never interrupt the return to the starting position. Once
this position is attained, the device switches off.
• Do not disconnect the device from the mains supply during operation. Always switch it off only once it has
reached the starting position at the bottom.
• D o not use the massage device for longer than 15 minutes and then allow it to cool. Using the device for
longer can over-stimulate the muscles and cause tension instead of relaxation.

8. Care and storage

Cleaning
WarnInG
• D isconnect the device before cleaning it.
• O nly clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• S maller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• D o not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
12