Intended Use; Operation; Initial Use; Switching On/Off The Shiatsu Function (Massage) - Beurer FWM 50 Mode D'emploi

• It is essential to observe the information relating to the following
chapters: Operation, Cleaning and maintenance, Storage.
• If you should have any questions about using our devices, please
contact Customer Services.

4. Intended use

This product is intended for warming and massaging human feet.
WARNING
Do not use the foot warmer with shoes, as they reduce your perception of heat and dirty the foot
warmer. This foot warmer is not designed for use in hospitals or commercial use. The following groups
in particular must not use the device: infants, small children, vulnerable persons, persons with low
sensitivity to heat or animals. Otherwise, there is a risk of injury.

5. Operation

5.1 Initial use

• Connect the mains part cable to the connector socket on the back of the foot warmer.
• Insert the mains part into the wall socket.

5.2 Switching on/off the Shiatsu function (massage)

• To switch on the Shiatsu function, press the massage button on the back of the foot warmer. The
massage heads will begin to rotate.
• To switch off the Shiatsu function, press the massage button on the back of the foot warmer again.
The massage heads will stop.
IMPORTANT
If too much pressure is exerted on the massage heads, the massage function will remain off for safety
reasons. In order to use the foot warmer again, briefly remove the cable from the connector socket
and then reinsert it.
5.3 Switching on/off the heat function (
• To switch on the heat function, press the heat button (
LED above the heat button will light up.
• To switch off the heat function, press the heat button on the back of the foot warmer again. The red
LED above the heat button will go out.

5.4 Automatic switch-off

The foot warmer will switch off after approx. 30 minutes for safety reasons. Press the massage or heat button
again if you wish to continue using the foot warmer.
Switch the foot warmer off and remove the mains part from the socket if you do not wish to continue using
the foot warmer after the timed switch-off.

6. Cleaning and maintenance

IMPORTANT
Before cleaning, always remove the mains part from the socket first.
Otherwise, there is a risk of damage.
Small marks on the foot warmer can be removed with a damp cloth and, if necessary, with a little liquid
detergent for delicate laundry.
)
) on the back of the foot warmer. A red
14