Publicité
B4-2— Dampen the mop cloth and wring it
until it stops dripping. Install the mop
onto the mop cloth mount and stick
it flat in place.
B4-3— Align the positioning hole and install
the mop cloth mount into the bottom
of the combo unit.
B4-4— Reinstall the combo unit into the
robot in place.
Notes:
• To avoid deformation, only use cold water.
• Do not rinse or immerse the dustbin and water tank
combo unit with water.
• To prevent damage, do not use any disinfectant and
only use cleaning solution recommended by Roborock.
• Dampen the mop cloth and wring it until it stops
dripping. Install the mop onto the mop cloth mount
and stick it flat in place. After mopping, empty the
water tank of unused water immediately.
• All combo units are subject to water-based tests before
leaving the factory. It is normal that a small amount of
water remains in the unit.
Connecting to the App
1. Download the App
Search for "Roborock" in the App Store or
Google Play or scan the QR code to
download and install the app.
2. Reset WiFi
Turn on the robot, then press and hold
and
simultaneously for three seconds
until you hear the "Entering network
configuration mode" voice message. The
reset is complete when the power indicator
light flashes wihte slowly. The robot will
then wait for a connection.
Notes:
• If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new
device.
• If you want to disconnect WiFi, reset the WiFi and make
sure the WiFi is successfully resetted. Then wait for 5
minutes and WiFi will be automatically disabled. lf you
want to reconnect, reset the WiFi before proceeding.
3. Add device
Open the Roborock app, tap the "Add
Device" or "+" button and add your device
following the in-app guide.
Notes:
• The actual process may vary due to ongoing app
updates. Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
Instructions for Use
Turning On/Off
Press and hold
to turn on the robot. The
power indicator light will come on, and the
robot will wait for orders.
Press and hold
to turn off the robot and
complete the cleaning cycle.
007
Note: The robot cannot be turned off when it is being
charged.
Starting Cleaning
Press
to start cleaning. The robot will plan its
cleaning route and in each room, it firstly
draws out edges and then fills the room in a
zigzag pattern. In so doing, the robot cleans all
rooms one by one, thoroughly and efficiently.
Notes:
• Before cleaning, tidy cords (including the power cord
of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cords and property.
• Before starting each cleaning task, make sure that the
mop cloths have been properly installed.
• To make sure the robot returns to the dock
automatically, start the robot from the dock and do
not move the dock during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting a cleanup.
• If the battery runs low during a cleaning cycle, the
robot will automatically return to the dock. After
charging, the robot will resume where it left off.
Pause
When the robot is running, press any
button to pause it, press
to resume
cleaning. Press
on a paused robot to
send it back to the dock for charging.
Note: Placing a paused robot on the dock manually will
end the current cleanup.
Emptying
After cleaning, the robot will return to the dock
and auto-emptying will automatically begin.
Publicité
