Publicité
Installation
B
Important Information
1. Tidy cords, hard or sharp objects (such as
nails and glass), and loose items from the
ground and move any unstable, fragile,
precious, or dangerous items to prevent
personal injury or property damage due
to items becoming tangled in, struck by,
or knocked over by the robot.
2. When using the robot in a raised area
(such as in a duplex apartment), always
use a physical security barrier to prevent
accidental falls that may result in
personal injury or property damage.
Notes:
• When using the robot for the first time, follow it
throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
• To prevent excessive buildup of dirt on the mop cloth,
floors should be vacuumed at least three times before
the first mopping cycle.
Positioning the Dock
B1
Place the dock on a hard, flat floor, flat
against a wall. Connect the power cord with
the dock and tidy up the excess cord. Make
sure that the location has good WiFi
coverage for a better experience with the
mobile app. Plug in and make sure that the
status indicator light is on.
B1-1—
More than 1.5 m (4.9 ft)
B1-2—
More than 0.5 m (1.6 ft)
Notes:
• Keep at least 0.5 m (1.6 ft) of clearance on either side,
1.5 m (4.9 ft) in front.
• If the power cord hangs vertically to the ground, it
may be caught by the robot, causing the dock to be
moved or disconnected.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon, otherwise
the robot may fail to return to the dock.
Attach the Moisture-Proof Mat
B2
After fixing the dock in place, use a dry cloth
to clean the area where the moisture-proof
mat will be located. Tear off the double-sided
006
tape at the bottom of the moisture-proof
mat, and stick the mat on the floor.
Notes:
• Always place the moisture-proof mat on wooden floors.
• When necessary, remove the double-sided adhesive
tape slowly to reduce residue glue.
• The moisture-proof mat attaches best to smooth
surfaces.
Powering On & Charging
B3
Before using, be sure to remove the film on
the dock locators on the front of and at the
rear of the robot. Press and hold
power on the robot. Wait until the power
indicator light is steady white, and then
place the robot to the dock. The robot is
equipped with a built-in high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the
robot charged.
Notes:
• The robot may not be turned on when the battery
is low. In this case, place the robot to the dock for
charging.
• The robot cannot be turned off when it is being
charged.
Starting Mopping
B4
Note: To prevent excessive buildup of dirt on the mop
cloth, floors should be vacuumed at least three times
before the first mopping cycle.
B4-1— Remove the dustbin and water tank
combo unit, open the water tank
stopper, and fill the water tank with
tap water before reinstalling the
stopper. Do not immerse the unit
into the water directly.
to
Publicité
