Pre-Maintenance Procedures; Moving A Non-Functioning Machine - Toro Timecutter Max Or Myride 54In Mode D'emploi

Pre-Maintenance Procedures

Moving a Non-Functioning Machine

1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine and wait for all moving parts to stop before leaving the operating
position.
3. Locate the bypass levers
4. Move both bypass levers forward through the slotted hole and over to lock them in place
.
Contact with hot surfaces may cause personal injury.
Keep your hands, feet, face, clothing and other body parts away the engine, muffler
and other hot surfaces.
The machine could unintentionally move while the bypass levers are locked forward
in the slot and injure you or bystanders.
Lock the bypass levers rearward after moving the machine.
3473-450A
position.
ARK
on the frame on both sides of the engine.
G438892
WARNING
WARNING
Page 5–3 Maintenance: Pre-Maintenance Procedures