Publicité
GENERAL OPERATION
1. GENERAL START
Plug power cord, turn on power switch, press [START], the machine could operate after 5 seconds
countdown.
2. MANUAL MODE
A) When power on, press [MODE] to begin manual mode.
B) There are 3 settings in manual mode: time setting, distance setting, calories setting.
----time setting: press [MODE] , then time window will flash. The original time is 30:00. Adjust time with
speed+-/incline+-, range:5:00-99:00.
----distance setting: press [MODE] twice, distance window will flash. The original distance is 1.0km. Adjust
distance with speed+-/incline+-, range: 1.0-99.99km
----calories setting: press [MODE] three times, calories window will flash. The original calorie is 50 kcal.
Adjust calories with speed+-/incline+-, range: 20-999.9kcal
C) Setting finishes, press [START], the machine begin operation until the target data countdown to 0.
3. PROGRAM MODE
A) Turn power switch on
B) Press [PROG], choose your favorite program. The default time for each program is 30 minutes. Press
[START], the machine begins operation. Or you could choose program by shortcuts on console.
C) Before operation, you could adjust default time with Speed+-/Incline+-.
D) During operation, you could adjust speed/incline with Speed+-/Incline+-
E) During operation, the machine will stop when you press [STOP].
F) When time countdown to 0, the machine stop operation.
4. USER PROGRAM
A) Press [USER PROG] to begin user program. Set time firstly, the default time is 30 minutes. Adjust time
with Speed+-/Incline+- , range:5:00-99:59 minutes. Press [MODE] to confirm setting and begin speed/incline
setting of each section.
B) There are 16 sections in user program. Adjust speed/incline with Speed+-/Incline+-, range: 1-24km/h, 0-15
levels incline. Press [MODE] to confirm setting and begin speed/incline setting of next section.
C) Setting finishes, press [START] to begin operation according to your setting.
D) The treadmill will memorize setting of user program, and operate accordingly if no new setting.
E) The machine will stop operation when time countdown to 0.
5. LUBRICATE THE RUNNING BELT
A) Press [START] for 10 seconds, the system will lubricate the running belt with warning sound. The lasting
time is about 5 seconds.
B) When current is over setting data, the machine will lubricate running belt automatically.
6. HANDLE PULSE
Hold pulse sensors on handles for 5-10 seconds, the handle pulse data will be displayed on console.
7. STOP TREADMILL
A) Press [STOP], the treadmill will stop.
B) Press [PAUSE], the treadmill will stop temporally.
C) Slap safety key, the treadmill will stop.
D) Turn off power switch, the treadmill will stop.
MAINTENANCE
How to adjust running belt
Tools required: Allen key set
Adjust running belt to be in middle location:
1. Turn power on and make treadmill run at low speed.
2. Check whether running belt is moving to left or right, whether it is in the middle of running deck.
3. If running belt is moving to left.
Publicité
