Publicité
Stop treadmill, tighten bolt on left end cap 1/4 turn clockwise. Then start treadmill and let it run at low
speed for 1 minute. If the running belt is still moving to left, repeat this step, until the running belt is in the
middle of running deck.
4. If running belt is moving to right.
Stop treadmill, tighten bolt on right end cap 1/4 turn clockwise. Then start treadmill and let it run at low
speed for 1 minute. If the running belt is still moving to right, repeat this step, until the running belt is in
the middle of running deck.
Adjust tension of running belt:
1. When you run and feel slipping, it means the running belt loosens and need to increase tension.
2. Tighten both bolts on left and right end caps 1/4 turn clockwise at the same time.
3. Run and check whether the slipping of running belt eliminates. If not, repeat 2 and 3 until slipping of
running belt eliminates.
Attention: DO NOT EXCEED ONE FULL TURN
Attention: DO NO MAKE THE TENSION OF RUNNING BELT TOO TIGHT.
Attention: TURN BOTH BOLTS ON LEFT AND RIGHT END CAPS 1/4 TURN ANTICLOCKWISE WILL
DECREASE TENSION OF RUNNING BELT.
Publicité
