Orbegozo RF 2500 Manuel D'instructions page 16

RF/RN 2500
USING THE THERMOSTAT AND POWER KNOBS
1. Switch the heater to one of the following power settings:
1: 1000W 2: 1500W 3: 2500W
2. Room temperature can be adjusted using the thermostat. Simply turn the thermostat knob
clockwise, to increase the heat, and anti-clockwise to decrease the temperature, until you reach the
desired temperature.
3. The power knob lights up when activated.
4. The thermostat control switch lights up when the unit is heating up. Once it reaches the set
temperature, the light will come off.
5. Once you have finished using your heater, turn the power switches, and the thermostat control
switch to the "0" position, and unplug from the mains supply.
Note: This radiator heater is oil filled, and will cool down slowly after the power is shut off. Allow the
radiator heater to cool prior to any movement; the built carry handle should be used for easy
movement. Do not cover the heater at any time during operation. There is a risk of fire if the heater is
covered.
CLEANING YOUR OIL RADIATOR
1. Always disconnect the heater from the mains supply before cleaning.
2. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
3. DO NOT use waxes or polishes as these may react with the heater and cause discolouration.
STORING YOUR OIL RADIATOR
1. Save the box for off season storage.
2. Clean the heater following the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the radiator, and wheel assemblies in the original box, and store in a cool and dry place.
5. If you choose to store your heater fully assembled, be sure to cover it to protect it from dust.
16