Publicité
Once the measurement process is complete,
the laser beam will switch off. For a further
measurement, repeat this process.
Press and hold the button
until the display
product.
When switching on for the first time, the meas-
uring tool will be in the length measurement
function. When switching on every subsequent
time, the measuring tool will be in the meas-
uring function that was last used. To select
another measurement function, press button
to enter the function menu, press
2
or
8
tion, then press
If no button is pressed for 5 minutes, the
product will automatically power off itself.
Selecting the reference level
For the measurement, you can select from various
reference levels:
The rear edge of the measuring tool
(e.g. when placing against walls)
The centre of the tripod thread
(e.g. for tripod measurements)
The front edge of the measuring tool
(e.g. when measuring from a table edge)
70 GB/IE
turns off to power off the
5
to select desired measurement func-
4
for 3 seconds
6
to confirm the selection.
1
Publicité
