Cable Transition Stv-Kü-T1 Ft (Sash- + Frame Part); Installation Sequence - Winkhaus blueMatic EAV Instructions D'installation, D'utilisation Et D'entretien

EN
Installation, Operating and Maintenance
Instructions blueMatic EAV
NOTICE!
a) The routing for the main lock housing must be 16 mm as minimum to provide for
free motion of the drive rod! Check the door eurogroove for sprue so that the free
1
motion of the rod is not impeded!
b) It is imperative to use always with a lever/fixed pad handle set (lever inside, door
knob outside)
2
3.2
3
Empfehlung: It is recommended that the cover plate 4 (depends on the faceplate and
the material type of timber, PVCu/plastic or aluminum) conceals the routing for the re-
quired cable reserves to prevent possible cable damage. For timber doors use the cover
4
plate, to hide the routering for the cable hole, and to prevent cable damage. The routing
for this wire hole should be approx 50 x 95 mm.
5
6
7
8
Figure 3.2-1: STV-KÜ-T1 FT with cover
plate and frame part 1
Aug. Winkhaus GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen
Subject to technical changes
Cable transition STV-KÜ-T1 FT (sash- + frame part)
28

Installation sequence

Frame part 1 2 (Figure 1):
• Drill a hole with a Ø 8 mm for cable through the
door frame
• Pass the cable through the door frame (inclu-
ding cable reserves in frame!)
• Fasten the frame part 1 2 with the fitting
screw 5 Ø 3 x 20 mm
Frame part 2 3 (Figure 2):
• Drill a hole with a Ø 13 mm for cable/plug
through the door frame
• Pass the Cable with plug for frame power sup-
ply through the door frame (including cable re-
serves in frame!) use STV-COVERING KÜ-T1 RT
R8
• Fasten the frame part 2 3 with the fitting
screw 5 Ø 3 x 20 mm
Print-no. 504 474 4
01/2017
www.winkhaus.de